Pluto – Make factory default

Knowledge Base - Controllers
13/05/2020
Print

When it is necessary to bring the Pluto back to Factory default, complete the following steps:

Configuration in iProtect™:
1. Open menu: “Installation” > “Hardware” > “Line”.
2. Click on the “Search” button.
3. Select the correct Pluto.

4. Under communication deselect “Active”.
5. Copy the password of the line.
6. Save this record.

Configuration in Pluto:
1. Browse to the maintenance page of the Pluto.
2. Login with username “controller” and the line password, generated in iProtect.
3. Select the menu “Advanced”.
4. Press on “Reboot”. Login into the maintenance page of the Pluto after 2 minutes.
5. Select the menu “Advanced”.
6. Press on “Make factory default”. The Pluto will automatically reboot after 5 minutes.

Note: Note: The password, configurations, network interfaces and iProtect data will be removed and set to default. (IP address is 192.168.1.195 and password is Pluto).

7. Login into the maintenance page of the Pluto. Login with username “controller” and the password “Pluto”.