Replace Polyx (2x kpBus) for Pluto and two Orions

Knowledge Base - Controllers
13/05/2020
Print

Configuration in iProtect™:
1. Open menu: “Installation” > “Hardware” > “Line”.
2. Select the correct “Line” which need to be replaced.
3. Under communication deselect “Active”.
4. Save this record”.

Configuring the Pluto:
1. Switch off the power supply
2. Write down the connections and disconnect it from the Polyx.
3. Install a Pluto in combination with two Orions (per Orion one kpBus). The Pluto and the two Orions are connected by using the stacking connector.
4. Connect the first kpBus (PRT2 of the Polyx) to PRT2 of the 1st Orion (this Orion is to the left of the Pluto).
5. Connect the second kpBus (PRT3 of the Polyx) to PRT2 of the 2nd Orion.
6. Connect the Pluto according to drawing and connect the Pluto to the network.
7. Switch on the power supply.
8. Open the Explorer and browse to the following address: https://192.168.1.195. The login screen appears.
9. Enter “controller” as username. The default password is “Pluto”.
10. On the maintenance page select “Network settings” and enter the desired information like IP address and IP address gateway.

Configuration in iProtect™:
1. Open menu: “Installation” > “Hardware” > “Line”.
2. Select the correct “Line” which need to be replaced.
3. Under communication select “Active”.
4. Press the button: “Send new KeyStore”.

When having the connection between iProtect™ and the Pluto in place, automatically the latest software update will be installed on the Pluto. This may take a few minutes. When finished, the “Current status” will be “Active”.

NOTE After the Pluto has communicated with iProtect™, the standard password will be changed. The new password will be displayed in the “Line details” screen.

5. Press the button: “Discover”. Both kpBus lines are converted.
6. Open menu: “General” > “Overviews” > “Last events” and check the operation.