Replace Polyx for Pluto and Orion

Knowledge Base - Controllers
13/05/2020
Print

Configuration in iProtect™:
1. Open menu: “Installation” > “Hardware” > “Line”.
2. Select the correct “Line” which need to be replaced.
3. Under communication deselect “Active”.
4. Save this record”.

Configuring the Pluto:
1. Switch off the power supply
2. Write down all connections and disconnect it from the Polyx.
3. Install a Pluto in combination with an Orion. Pluto and Orion are connected by using the stacking connector.
4. Connect the Pluto according to drawing and connect the Pluto to the network.
5. Connect the IO contacts to the Orions.
6. Connect the card readers to PRT1 and / or PRT2 of the Orion.
7. Switch on the power supply.
8. Open the Explorer and browse to the following address: https://192.168.1.195. The login screen appears.
9. Enter “controller” as username. The default password is “Pluto”.
10.Select “Hardware” and activate “Diagnostics”. Diagnostics enables automatic detection of devices connected to the Pluto and testing of it. Deactivate diagnostics after successful test.
11. On the maintenance page select “Network settings” and enter the desired information like IP address and IP address gateway.

Configuration in iProtect™:

1. Open menu: “Installation” > “Hardware” > “Line”.
2. Select the correct “Line” which need to be replaced.
3. Under communication select “Active”.
4. Press the button: “Send new KeyStore”.

NOTE When having the connection between iProtect™ and the Pluto in place, automatically the latest software update will be installed on the Pluto. This may take a few minutes. When finished, the “Current status” will be “Active”.

5. Open menu: “General” > “Overviews” > “Last events” and check the operation.